Airflow pulverized product except for particle size, there is also a narrow particle size distribution, smooth particle surface, particle shape regular, high purity, high activity, good activity, and good activity. Since Single Classifying Wheel Classifier OF BATTERY MATERIAL generates a Juromon cooling effect during the pulverization process, it is also suitable for low melting point and ultrafine pulverization of thermal materials. The gas-solid ratio in the pulverization process is an important technical parameter and important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. However, if the gas ratio is too high, not only the amount of energy is wasteful, but even the dispersion of certain particles will also becomerated. When the feed is grained, when the hard material is pulverized, the particle size of the feed is more stringent. In the case of titanium powder, when the calcined material is pulverized, it is necessary to control 100-200 mesh; the material after the pulverization surface is generally 40-70, and cannot exceed 2-5 mesh.
Single Classifying Wheel Classifier of Battery Material is: 1. High yield, low energy consumption, high grading efficiency. 2. Particle size: This unit is graded by an impeller. The stable grading process and special sealing measures effectively prevent the leakage of crude particles, so that the product has no large particles, the particle size is concentrated, and the grading accuracy is high. 3. The structure is reasonable, and 1-6 products can be produced at the same time according to user requirements. 4. Strong applicability: A closed or open joint operation can be combined with a variety of mill (air mill, mechanical mill, ball mill, Raymond mill, vibrating mill, etc.). 5. High degree of automation.
Do you know how to correctly use Single Classify Wheel Classifier of Battery Material? I hope the content below can help you. 1. Preparation before the comminution is started to check whether the host, joint, pipeline, and the valve are normal, working properly. 2, open the pulverizer (1) Open the compressor power supply, dustpress pressure valve and the main valve, open the power switch of the pulverizer, turn on the power switch. (2) From zero, gradually adjust to the specified speed. (3) Open the fan, cyclone separator, dust removal and charging power, open total powerThe box, set the frequency of the inverter, and then start charging. (4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel. 3, pulverizer shutdown is: inverter - feeder - main valve compressor - compressive type impeller motor - cyclone material, dust removal switch - fan - universal power supply air compressor. 4, eddy current pulverizer maintenance (1) Regularly lubricate eddy current crushing machine, but the lubricant should not be too large to prevent the bearing temperature too high. (2) Check the wear of the impeller, screw conveyor and the crushing nozzle. (3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect. (4) After a filter bag, the vortex pulverizer is filtered, and it should be cleaned or replaced. 5, Eddy Current Crusher Precautions (1) When the discharge equipment is running, the unloading port cannot be reached, and the accident occurs. (2) The rotational speed of the impeller should not exceed the specified requirements, otherwise the temperature is too high, the impeller and the electric chance are damaged. (3) Regularly check the safety valve to ensure safety.
