Environmentally friendly Single Classifying Wheel Classifier Pesticides has gradually become the market leading to mechanical equipment. At this stage, the modern new mechanical equipment in the machinery processing and manufacturing industry has gradually replaced the traditional rough mechanical processing production, and the production of environmentally friendly machinery is also In the event of a new dominant leading for the realization of technological innovation and upgrading.
In addition to the particle size, the airflow crushing product has the characteristics of narrow particle size distribution, smooth particle surface, high purity, high activity, good dispersibility. Since Single Classifying Wheel ClassifierPESTICIDES causes a Juromon cooling effect during the crushing process, it is also suitable for ultrafine pulverization of low melting point and thermal material. The gas-solid ratio in the pulverization process is an important technical parameter and important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. However, if the gas ratio is too high, not only the amount of energy is wasteful, but even the dispersion of certain particles will also becomerated. When the feed is grained, when the hard material is pulverized, the particle size of the feed is more stringent. In the case of titanium powder, when the calcined material is pulverized, it is necessary to control 100-200 mesh; the material after the pulverization surface is generally 40-70, and cannot exceed 2-5 mesh.
Single Classifying Wheel Classifier Pesticides works by a grace machine, a cyclone separator, a dust collector, and a veneer. Under the pulverizer pulling force, the lower end of the gas pulverizer is moved upward to the grading area, and the coarse, and the fine product is separated from the high-speed rotation grading turbine. The cyclonic separator or dust collector is collected by the grading wheel, and the fine particles required to meet the particle size are collected, and the coarse particles are collected. The speed of the ellable fine particles disappears and falls along the two air ports of the cylinder wall. The crude particles and fine particles separated by strong purification of the two winds, and the fine particles rose to twice the grade region, and the crude particles drops to the discharge port.
In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, and should pay attention to the adjustment.The proper tightness of the whole leather belt ensures the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
