With the continuous development of pulverizer technology, Large Rotor Mill for Sale has gradually penetrated into people's daily lives.
What factors affect the performance parameters used by the LARGE ROTOR MILL for Sale?
The following is a detailed description:
1. Feeding granularity control
Most large rotor mill for Sale has a certain upper limit requirement for feed particle size. After entering the pulverization cavity, it can be sufficiently accelerated before collision and crushing with other particles. It is difficult to completely accelerate after large particles enter the pulverized cavity, which will allow them to stay in the machine too long, resulting in too high energy consumption. Therefore, in large-scale production of ultrafine powder, it is an effective way to pre-ground the raw material of the particle size is an effective pathway for energy saving.
2. Working medium
At present, the working medium of Large Rotor Mill for Sale is mainly compressed, superheated steam, inert gas, and the like. The choice of working fluid has a certain impact on crushing effects and economics. Superheated steam is superior to air in fluidity and critical flow rates to achieve higher flow rates and uniform flow fields. However, using superheated steam as a working fluid, it must be ensured that it is still in an overheating state before entering the product capture device, otherwise the material is condensed.
3. Feeding speed
Feeding speed is an important parameter reflecting gas flow grinding production capacity. During the pulverization process, the optimum ratio of the intake flow rate and the feed speed is the key to improving the crushing efficiency. In general, under certain intake flow conditions, the feed speed is proportional to the particle size of the product. However, the feeding speed is too fast, which will increase the particle density, mutual interference, disadvantage of the particles, and difficult to achieve the sufficient and effective collision between particles, affect the crushing effect; although the feed speed is too slow, the particles stay in the crush area The time can be extended, which will reduce the particle density, reduce the collision rate, resulting in a decrease in production capacity and an increase in unit production energy consumption.
4. Granular limit
During the pulverization process, as the material particle size is reduced, the crystallization and intensity of the material increases. After reaching a certain degree, the particle size of the material is no longer reduced or reduced, that is, the crushing limit of the material is reached. At this time, the material specific surface area increases, the surface activity of the particles, the particle agglomeration and grinding are in a dynamic equilibrium state, even if the grinding time is prolonged, it is difficult to further reduce the particle size of the material.
AlPa calcium carbonate sharing with Large Rotor Mill for Sale: This customer isA stone powder company, mainly engaged in production and processing of calcium carbonate, magnesium oxide and other products, which requires grading sorting of calcium carbonate ultrafine powder, grades the product of the desired particle size.After the experiment, as well as the production requirements, our AlPA's host can reach the company's needs, and finally purchased a plurality of graded units of our company.
Welcomes the major calcium carbonate flour manufacturers with powder grading to factory to visit and incurred.
Shan Dong Alpa is a scientific and technological private enterprise producing various airflow pulverities, airflow mills, disc gap pulverities, disc air crushers.
