Rod Pin Mill of Lithium Cobal Oxide

Rod Pin Mill of Lithium Cobalt Oxide is good, only need to be produced in a smooth ground place, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.

Rod Pin Mill of Lithium Cobalt Oxide is based on the size of the powder particle size, the specific gravity is different, and the settlement speed is different from the principle of the settling speed in the gas. The classifier, cyclone separator, dust collector, and the introducer make a set of hierarchical systems. Under the action of fan pulleys, the material is moved at a high speed, and the up airflow into the grading area. Under the action of the powerful centrifugal force generated by the high-speed rotation grading turbine, the coarse, fine particles are separated, and the fine particles that meet the particle size requirements by the gap of the grading wheel blades or the dust collector are collected. After the crude particles are partially fine particles, the velocity along the wall to the secondary air is disappeared and reduced.

The strong washing effect of the secondary wind, the thick particles are separated, and the fine particles rise to the secondary level of the secondary level, and the crude particles reduce the discharge port.


ALPA Battery Rod Pin Mill of Lithium Cobalt Oxide Case Sharing:

A new energy company is a high-tech enterprise specializing in research and development, production and sales of new energy materials. Committed to the research and innovation of new energy materials, the company's products include a special tetracantoxide of lithium batteries, magnetic material tetraside and lithium battery positive electrode material.

The company has advanced technology and excellent quality, and has established a complete quality management operation system.
Case parameters
Product particle size: D50: 15μm
hour yield: 600kg

How to correct ROD PIN MILL OF LITHIUM COALT OXIDE?

Before the device is turned on, the connection site, seal And the line and the like are meticulous inspections, and everything can be checked if there is no problem before running the powder classifier.

The boot should be operated in the boot order. 3 minutes before shutdown should be stopped, then shut down, the order is opposite to the boot order.
The amount of feed should be determined according to the size of the powder grading machine load, ensuring that the host is in the state of rated load. The particle fineness can be adjusted to adapt to the grading requirements.
Debutors such as the heat-sensitive material, then the power of the main motor is slightly lower than the rated power. The size of the air volume in the delivery line can be achieved by adjusting the damper of the fan.
Welcome everyone chooses usShandong AlPa, the company specializes in the production and development and service of airflow crusher product technology, the company provides customers with safe and reliable ROD PIN MILL OF LITHIUM COBALT OXIDE products and services to solve the worries of customers.