Hammer Crusher For Solid Sorbitol is better, only need to be produced in a smooth ground, and low noise, which can avoid dust leakage during the pulverization process, which is favored by the powder industry.
What is the design structure of Hammer Crusher for Solid Sorbitol?
Under the action of the high-speed rotary impeller, the gas pressure flowing through the impeller increases, and the high pressure airflow flows out of the impeller, the fine particles are ejected. Since the blade of the rotary vane is designed as a bending, the inlet is large, the exit cross-sectional area is small, so the airflow pressure at the outlet is reduced, the speed increases, and the rotational flow is conducive to classification.
The grading point adjustment mechanism sets three adjustment rods and keeps its synchronous motion using the chain. When the adjustment rod moves up, the fine powder increases; when the adjustment rod moves down, the fine powder is reduced. The grading point can be continuously adjusted, and the performance of Hammer Crusher For Solid Sorbitol is steplessly adjusted. The granular weight product can reach D97 ≤ 3 ≤ 150 microns, which is suitable for fine grading of dry micro-micro products.
The setting of the control ring is to ensure that the control ring is formed between the control ring and the radial particles ring, and the stability of the airflow flow is controlled. The residual windlet inevitably introduces excess gas from the dry material, the temperature of the classification chamber is high, and the air can expand, and therefore designed a residual tightening to maintain the stability and balance of the graded indoor airflow.
ALPA Chicken Protein Hammer Crusher For Solid Sorbitol Case Sharing: The company is a Spain, the company needs to smash a chicken protein, asking a few powder equipment companies in Europe. There are no suitable equipment. Later, I learned that our ALPA, the testism sent us a message, and we didn't know if it was received after receiving the email. But our ALPA still decided to try it, and then let the customer maidens will be experimentally. Through multiple experiments, we have identified a crushing equipment that meet the particle size needs of the company. Finally, the company also purchases the series of equipment.
Technical parameters:
Finished granularity: 100μm
How to control the size of the particle size?
The smaller particle size of the raw material, smash The higher the efficiency, the larger the particle size of the raw material, so the crushing effect is relatively low. In the case of crushing pressure and feed pressure, reduce the feed speed product will be finer, and improve the feed speed product will become thick. In the case of a certain amount of feed,High-pulverized pressure product particle size will be finer, reduce the pulverization pressure, and the product will become thick.
So the particle size control is the adjustment of the parameters during the pulverizer to achieve different pulverized fineness, and it is necessary to measure the relationship between the feed velocity and pressure before crushing and then determine the appropriate pulverization parameters.
