Cell Pulverizer for Synthetic Resin is a mechanical equipment applied to the production area, which is mostly used in pulverizing particles, fast pulverity, good accuracy.
Cell Pulverizer for Synthetic Resin :
With the high-pressure airflow with the animal, it is shredded, ensuring the purity of the material, and facing the high hardness of the material can be used as a pulverized cavity, which greatly reduces the wear of the material to the pulverizer to ensure the purity of material purity. The low temperature is pulverized, or an inert gas is pulverized, such as nitrogen, carbon dioxide, is suitable for high activity, flammable and explosive non-metallic mineral powder.
High capacity, efficiency; compared with other ultra-fine pulverizations of the same capacity, because Cell Pulverizer for Synthetic Resin continuous feed, continuously pulverized, continuous recovery, the characteristics of continuously improvement increases, With the mode of automation control, the advanced level is much higher than other devices.
The structure is simple, the disassembly and cleaning is convenient, there is no need to lubricate oil, etc.
The product is fine, the particle size distribution is uniform, and the classification effect of Cell Pulverizer for Synthetic Resin comes greatly, and then cooperate with the Cell Pulverizer for Synthetic Resin. Use more to make the product particle size and distribution far better than the processing of other equipment.
A mining company specializes in the development and production of stone-shaped sand, silicon powder,
company produces various models Quartz sand and water-washing dry stone sand and water-shaped, water, precision cast, furnace, refractory, ceramic glaze, ceramic billet, rubber, coating, etc. , Welcome to find, guide, negotiate business!
Case parameters:
Product particle size: D100: 11.5UM
Hour Yield: 380kg
In production, a certain number of thingsThe material must be maintained in the airflow grinding chamber.In the case where the flow rate of the pulverized gas is not changed, the material in the grinding cavity is large, the gradient current is large, and the material is small in the grinding cavity, the gradient current is small.
In addition, the feeding speed must remain uniform and stable, don't be too fast or too slow.
If the feeding speed is too fast, the device will overload.
Regular maintenance equipment, often check whether the air supply pressure meets the pressure required, and the gas flow grinding motor, after 3,000 hours of operation, or long-term shutdown and long-term storage, should be cleaned in a gas flow grinder nozzle and grindingThe inner wall of the cavity and attached to the material grading portion to prevent the effect of gas flow grinding on the grinding effect.
