In this economically flourished area, there are many people who know the airflow pulverizer, Rod Pin Pulverizer of Oatmeal technology is in a leading position in the same industry.
A rod pin Pulverizer of Oatmeal costs, if you want to use Rod Pin Pulverizer of Oatmeal for a long time, please pay attention to the following points:
1. During the production process, Temperature rises in the bearing frequently, when the temperature rise exceeds 50 ° C, the examination should be stopped, find out the cause, and troubleshoot.
2. When the new machine is running, the transmission belt is easy to eliminate, so it should be noted to adjust the appropriate tightness of the belt to ensure the life of the belt.
3. Test and timely replacement of vulnerable parts should be performed in time to ensure quality and production.
4. The wear of the blade and bushing should be continuously checked. If the productivity is lowered, the particle size is thick after wear, and the wear is immediately replaced.
5. 5.Rod Pin Pulverizer of Oatmeal Host and level score bearing use 2 special grease (265-295 degrees) lubrication.
6. The replacement period of the bearing is 2000 hours, and the amount of oil filling of the bearing chamber gap is 1 ≤ 2 (try) or 3 ≤ 4 (try), if it is not too much, the bearing temperature Will be too high.
7. The replacement period of the spiral feeder is 4,000 hours, and ordinary calcium based grease is added. Standard operation to exchange for longer use of airflow crushers.
The above is a 7 point introduction to the Rod Pin Pulverizer of Oatmeal's daily maintenance.
ALPA Battery Rod Pin Pulverizer of Oatmeal Case Sharing: Shandong Yantai Chemical Materials Company . Technical parameters finished particle size: D50: 8-12UM production capacity: 50kg / h
Rod Pin Pulverizer of Oatmeal is widely used, do you know how to use it correctly? The following content hopes to help you.
1. Preparation before departure. Check if the host, connector, pipeline, and the valve are normal, working properly.
2, open the machine
(2) From zero, gradually adjust to the specified speed.
(3) Open the fan, cyclone separator, dust collector, charge motor, open the total power box, set the inverter frequency, and then start charging.
(4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel.
3, the sequence of stops:
inverter-feeder-main air valve-compressor-grade impeller-motor cyclone material, dust removal switch-fan-main power supply-air compressor .
4, Maintenance
(1) The motor should be lubricated regularly, but the lubricating oil should not excessively avoid the bearing temperature.
(2) Check the wear of impeller, helical conveyors, and crushing nozzles.
(3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect.
(4) After the filter bag, it should be cleaned or replaced.
5. Precautions
(1) When the discharge equipment is run, the unloading port cannot be reached, and the accident occurs.
(2) The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller, and the electric chance are damaged.
(3) Regularly check the safety valve to ensure safety.
The technology of Rod Pin Pulverizer of Oatmeal produced by AlPa makes the structure easier to make the classifier wear resistance. Friends needed to come to us!
