With the rapid growth of China's economy, high-energy mining machinery industry, especially Hammer Mill for Tobacco Stalk, there will be a huge development space, and various mineral powder products will develop rapidly. In order to ensure sustainable development, green, environmentally friendly, healthy bed jet rubbing equipment and products more extensive in the entire mineral powder industry. When applied to people's lives, it is necessary to optimize the use of equipment technology.
Hammer Mill for Tobacco Stalk is mainly used for more refined materials. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved. The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).
When the airflow is classified, the fine product is usually taken away by the airflow. In some cases, the raw material is sent to a pulverized device from the airflow.
As is well known, the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.
The speed required to move the particulate material in the horizontal and vertical direction is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverized coal and Western / cubic centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.
in the rising airflowThe airflow speed required to suspend a certain density and particles of the particle size is greater than the calculated value of the free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.
The Hammer Mill for ToBacco Stalk has a wide range of unclear, high pulverization efficiency, high pulverization accuracy, accurate cut particle size, and good stability.
ALPA Phenolic Resin Hammer Mill for Tobacco Stalk Case Sharing: The company has a manufacturer of phenolic resin in its customers, and the company has found a lot of powder equipment companies without suitable equipment. Finally, we found our AlPa, after the experiment, our company's product Hammer Mill for Tobacco Stalk.
Technical parameters:
Production capacity: more than 50kg / h
Today, I will introduce you here, I want to know more information, please Continue to pay attention to our website.
