FL / ITC Single Classify Wheel ClassifierDrug Granules should be installed in place to use convenient place. Before you work, you should pick up the processed material, no metal, stone, etc., hard substances, mix into the machine, so as not to damage the parts in the machine or failure. Check that each component is firm and reliable before booting. Everything is normal, you can work on the power, turn it in 1-2 minutes, check whether the operation is normal, everything is normal, it can be pushed. When working, the operator cannot leave. Once the sound is abnormal, the power should be disconnected immediately. When machining raw new friends Chinese medicine crusher, the discharge port should be tiered with a long cloth bag. When the pulverizer is in use, if you encounter a power supply voltage, do not use it, so as not to damage the motor. When the power supply voltage is normal, the machine is not easily damaged, and the production efficiency is high.
Fl / ITC Single Classify Wheel ClassifierDrug Granules consists of a grace machine, a cyclone separator, a dust collector, and a veneer. Under the pulverizer pulling force, the lower end of the gas pulverizer is moved upward to the grading area, and the coarse, and the fine product is separated from the high-speed rotation grading turbine. The cyclonic separator or dust collector is collected by the grading wheel, and the fine particles required to meet the particle size are collected, and the coarse particles are collected. The speed of the ellable fine particles disappears and falls along the two air ports of the cylinder wall. The crude particles and fine particles separated by strong purification of the two winds, and the fine particles rose to twice the grade region, and the crude particles drops to the discharge port.
How to correctly operate the FL / ITC Single Classify Wheel ClassifierDrug Granules? Before the device is turned on, the connection location, sealing and line, etc., all check, there is no problem, and can run the powder classifier. The boot should be operated in the boot order. 3 minutes before the shutdown should be stopped, then shut down, and the order is opposite to the boot order. The amount of feed should be determined according to the size of the powder grading machine load, ensuring that the host is in the state of rated load. The fineness of the particles can be adjusted to adapt to the grading requirements. If the device such as a classifier is separated, the power of the main motor isIt is slightly lower than the rated power. The size of the air volume in the delivery line can be achieved by adjusting the damper of the fan.
