Most of the product production and processing in the current stage uses Single Classify Wheel Classifier for Natural Flake Graphite to make products for products, which is one of the most common ways of processing, accompanied by the continuous improvement of scientific productivity, grading The technical replacement of the equipment is also imminent. The performance and internal configuration of the grading equipment of the airflow must also keep the trend of the era to continue the upgrade of the product.
In the production process of breaking using Single Classify Wheel Classifier for Natural Flake Graphite, the ultrasonic air flow generated by the device can constantly collide between materials, and this supersonic airflow can also It has a good impact to raw materials, and then the material can also have a good crushing effect with the inner wall of the equipment.
During the production process, the temperature rise of the bearing must often be checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this regulator is used with N32 alkaline high-z7-degree anti-motor oil pressure oil, and the deceleration machine is used 401 generally lubricating oil, and it is not necessary to use other machines. After four or five months, new oil should be replaced.
For friends who want to know other crusher industry knowledge can also log in to the website. If you have our Single Classify Wheel Classifier for Natural Flake graphite is interested in, please feel free to contact us.
