With the increasing social demand, FL / ITC MULTIPLE CLASSIFY WHEEL CLASSIFIERPLASTER is facing huge challenges. Therefore, ALPA Technology Co., Ltd. persisted unremitting, continuously improving the ultrafine grade strength, particle size distribution, particle crystal form and other regulation and control technology to achieve more production. AlPa, strive to achieve low-energy consumption, high production, high yield, non-pollution, achieve good granularity, dispersion, unique and potential performance of the product, improve the competitiveness of powder classifier, enhance environmental protection and low power performance .
Do you know how to correctly use FL / ITC Multiple Classify Wheel ClassifierPlaster? I hope the content below can help you. 1. Preparation before the comminution is started to check whether the host, joint, pipeline, and the valve are normal, working properly. 2, open the pulverizer (1) Open the compressor power supply, dustpress pressure valve and the main valve, open the power switch of the pulverizer, turn on the power switch. (2) From zero, gradually adjust to the specified speed. (3) Open the fan, cyclone separator, dust removal and charger power, open the total power box, set the frequency of the inverter, and then start charging. (4) The particle size of the finished product can be adjusted according to the frequency and bearing capacity of the grading wheel. 3, pulverizer shutdown is: inverter - feeder - main valve compressor - compressive type impeller motor - cyclone material, dust removal switch - fan - universal power supply air compressor. 4, eddy current pulverizer maintenance (1) Regularly lubricate eddy current crushing machine, but the lubricant should not be too large to prevent the bearing temperature too high. (2) Check the wear of the impeller, screw conveyor and the crushing nozzle. (3) After pulverizing the material, the rubber powder should be removed to avoid clogging, thereby affecting the crushing effect. (4) After a filter bag, the vortex pulverizer is filtered, and it should be cleaned or replaced. 5, Eddy Current Crusher Precautions (1) When the discharge equipment is running, the unloading port cannot be reached, and the accident occurs. (2) The rotational speed of the impeller should not exceed the specified requirements, otherwise the temperature is too high, the impeller and the electric chance are damaged. (3) Regularly check the safety valve to ensure safety.
