Most of the product production and processing of products in the current stage, using Cell Pulverizer of Dried Plum, the use of Cell Pulverizer of Dried Plum is a very common way of processing method, accompanied by the continuous improvement of scientific productivity, grading equipment technology It is also imminent to replace. The performance and internal configuration of the grading device of the airflow must also keep the trend of the era to continue the upgrade of the product.
Cell Pulverizer of Dried Plum is mainly used for more refined materials. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved. The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settle more in the air than in the water. Moreover, the density and viscosity of the air varies with temperature and pressure.
In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).
When the airflow is classified, the fine particles are typically taken away by the airflow. In some cases, the raw material is sent to the gas stream into a pulverized device.
It is well known that the load of solid particles in air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volume concentration of the solid in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.
The speed required to move the particulate material in the horizontal and vertical directions is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverization coal per centimeter. The minimum wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimum speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.
In the rising airflow, the airflow speed required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.
The Cell Pulverizer Of Dried Plum has a wide comminuted range, high pulverization efficiency, high pulverization accuracy, accurate cut particle size, and good stability.
AlPa Hardstone Powder Cell Pulverizer Of Dried Plum Case Sharing:
A gypsum company is a stoneCream mining, calcium sulphate powder R \u0026 D, production, sales, exports are integrated industrialized enterprises, company products are widely used in building materials, molds, food, medicine, rubber, plastics, coatings and other industries.
Case parameters: 4-15UM
Hour Yield: 3-6T
Cell Pulverizer Of Dried Plum Motor Maintenance Measures
1, check whether the lubrication of the bearing is Good
2, check if all fasteners of the pulverizer are fastened.
4. Check if the protective device of the crusher is good. If the protective device is found to be abnormal, it should be excluded in time.
5. Check that there is an absence of material or other debris in the damage chamber. If it is sometimes handled in time.
6, check whether the hydraulic starting machine head or the starting rod is returned, and the gasket is adjusted to be properly and compressed.
Welcome everyone to inquire!
