With the development of society, the application of Vibration Mill Machine With AGAR has become more large.
Vibration Mill Machine with AGAR's temperature increases, and when the temperature of the working fluid is too high, the flow rate of the gas will increase. Take air as an example, the critical speed at room temperature is 320 m / sec, when the temperature rises to 480 ° C, the critical speed can be increased to 500 m / sec, that is, the kinetic energy increases by 150%. Therefore, increasing the temperature of the working fluid is conducive to improving pulverization. The pressure of the working fluid is the main parameters of the jet speed, but also the main parameters affecting the fineness of the break. Typically, the higher the pressure of the working fluid, the faster the speed, the greater the kinetic energy.
When titanium powder is pulverized by superheated steam, the vapor pressure is usually 0.8 to 1.7 MPa, and generally pulverized calcined material is high, and the material after pulverized surface can be lower.
How to solve the problem of VIBRATION MILL MACHINE WITH AGAR noise? Let's take a look.
1. If a lubricating oil is added to the rotating section, if the bearing and the shaft are relieved, the bearing will be adjusted; if the bearing wear is impeded, the bearing will be replaced.
2. There is also noise during the pulverization. The cooling sleeve can be used to reduce the temperature, which can allocate water in the crushing chamber.
3. Install a muffler on the fireplace of the crushing room.
4. Resistance equipment, such as using damping boards.
