With the development of society and life, the demand for FL / ITC Multiple Classify Wheel Classifier of Multiple Classify Wheel Classifier of Multiple Classify Wheel Classifier of Multiple Classify Wheel Classifier of Multiple Classify is increasingly high. In the current market, there is a great development space.
FL / ITC Multiple Classify Wheel Classifier of Metallic Silicon is different from other crushers, which are collisions between particles, airflow impact and shear, high-speed airflow impact, friction and shear Cutting and other components for pulverized pulverizer. It has the following main features: 1. The grinding temperature is low, can pulverize the thermal, low melting material. According to the high-speed jet Joule effect, when the gas is thermally expanded, the gas will cool itself, thus canceling the heat generated by collision and friction. 2, short production cycle, high release rate. Due to high-speed collisions and closed crushing, the probability of collision between materials is very large, and dust does not leak. 3. Products having high purity (less pollution), uniform particle size distribution (D95 cumulative frequency) can be obtained. 4. Some materials that require wet pulverization can also be pulverized by airflow pulverization to achieve uniform and small powder. 5. A variety of joint operations can be achieved, and drying operations can be achieved. It can be seen that the research hotspot of the air pulverizer is very highlighted, and it plays a raised role in the pharmaceutical industry.FL / ITC MULTIPLE CLASSIFY WHEEL Classifier of Metallic Silicon works with high-speed rotating hammers hit materials, crushing the decision surface, the obedient surface and the natural gap. The material sent to the crusher is affected by the rotor, and the rotor rotates around the central axis at a speed of 25 to 40 m / s, and breaks the first time. The material then obtains the energy disc from the rotor, flying on the hard wall at high speed, and performs secondary comminution.
Installation, operation, and maintenance are three uses FL / ITC Multiple Classify Wheel Classifier of Metallic SiliconKey factor. The wear and consumption of each operation has always been a key factor in each startup operation. In order to use the airflow pulverizer for a long time, please adjust the open mode. The boot is the standard, for the first time to contact and use this kind of equipment, it is always in a very strange state. In fact, it is very simple, the best way is to familiarize with the consumer content on the instructions or have no use of value. Timely standardized and familiar. Check the airflow pulverizer in time to develop a good usage habit. In the future, we don't need to pay attention to and familiarize. The airflow pulverizer has improved and improved from the design and component combination, gave us a lot of help. It is good quality, but it is also declining long-term not maintenance and maintenance. Check the operating components, electrical components, and transmission. Once an abnormality occurs, please repair it in time, without a fault, gas mill, prevent accidents.
