As is well known, FL / ITC Multiple Classify Wheel Classifier with Precipitated Silica This product technology has received extensive attention from the industry.
FL / ITC Multiple Classify Wheel Classifier with Precipitated Silica's working principle consists of a grace machine, a cyclone separator, a dust collector, and a guide. Under the pulverizer pulling force, the lower end of the gas pulverizer is moved upward to the grading area, and the coarse, and the fine product is separated from the high-speed rotation grading turbine. The cyclonic separator or dust collector is collected by the grading wheel, and the fine particles required to meet the particle size are collected, and the coarse particles are collected. The speed of the ellable fine particles disappears and falls along the two air ports of the cylinder wall. The crude particles and fine particles separated by strong purification of the two winds, and the fine particles rose to twice the grade region, and the crude particles drops to the discharge port.
Let's talk about how to use FL / ITC Multiple Classify Wheel Classifier With Precipitated Silica. 1. Prepare for check hosts, attachments, pipes, and valves before booting. Whether it is intact, whether it works fine. Second, open 1. On the compressor power supply, the pressure valve and the main air valve of the dust collector, then turn on the power switch of the powder machine, and turn on the power. 2. The zero start classification wheel is gradually adjusted to the specified speed. 3. Turn on the fan, the cyclone separator discharge, dust removal, feed motor power, and then turn on the total power supply of the tube bar, set the inverter frequency, and then begins to break. 4. The granularity of the finished wheel can be adjusted by grading wheel frequencies and charging. Third, the sequence of shutdown is: inverter - feeder - Main valve - Compressor - Steady wheel motor - Cyclone discharge, dust removal switch - Fan - Total Power - Air Compressor. Fourth, repair 1. The motor should be lubricated regularly, but the grease should not be too large, the bearing temperature is too high. 2. Hierarchical impeller, spiral feeder, crushing nozzle wear should pay attention to check, belt tight and suitable. 3. After a crushing material, after a certain period of time, it is necessary to remove the inner sticky of the chalk, so as to avoid blocking, thereby affecting the crushing effect. 4After the filter bag, you should clean or replace it. 5. Precautions 1. When the discharge device is running, the unloading port cannot be extended to avoid accidents. 2. The rotational speed of the impeller must not exceed the specified requirements, otherwise the temperature is too high, the impeller and electricity will be damaged. 3. Regularly check the safety valve to ensure safety.
