FL / ITC MULTIPLE CLASSIFY WHEEL Classifier Of Talc is suitable for combating machinery of materials such as synthetic resins, food, chemicals. The apparatus is different from the ordinary inner grinding machine, not only simply crushed such as impact force and cutting force, but also by many generated ultrasonic eddy currents and vibration thus produced high frequency pressure vibration to crush the material. Under certain conditions, the viscous material and the elastic material can also be pulverized. The pulverizer has little increase in the cyclic temperature during the pulverization process, so the thermal material can also be pulverized. The pulverizer has a reasonable structure, stable operation, low energy consumption, large crushing capacity, small size, no fault, easy to clean, and maintenance. Generally, the outer casing uses water cooling and its own air volume, conveying crushing material, improves the temperature, and reducing the thermal material. The wear of the blade is caused by a large amount of ultrasonic vortex generated by the back of the blade and the vibration of the high frequency pressure. Compact structure, no dust, no problem.
FL / ITC Multiple Classify Wheel Classifier of Talc Applicable range: The grinding mechanism of the machine determines that its application range is wide, and the fine product is high. Typical materials are: super hard diamond, silicon carbide, metal powder, high purity requirements: ceramic pigment, medicine, biochemical, low temperature requirements: medicine, PVC.
In the production process, the temperature rise of the bearing must be often checked, and when the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault. When the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt. If you want to check, you should replace production quality and production in time. Blades, the lining should often check the wear situation. If the wear is worn, the productivity decreases, and the particle size is replaced after the particle size is replaced. The host and the grading flow bearing are lipids, and the 2nd special lipid is used. The replacement period of the bearing is around three months, and the filling of the grease is 1/2 of the outer space space in the bearing cavity. Do not fill the grease. Otherwise It will cause too high of the bearing temperature. The spiral feeder has changed the lime than half a year, and the calcium-based grease is added. In the output shaft E, ie the pulley E, avoiding heavy hammer, damage the part. It is strictly forbidden to turn the handle on the stop. The lubricating oil used in this register is used with N32 alkaline high-z7-high-grade anti-motor pressure oil, and the deceleration machine is 401 general lubrication.Oil, do not replace it with other machines. After four or five months, new oil should be replaced.
